Troy-Bilt LS275 Uživatelský manuál

PRINTED IN U.S.A.FORM NO. 769-00088.fm(2/2002)Operator’s ManualIMPORTANT: Read safety rules and instructions carefully before operating equipment.TROY

10SECTION 5: ADJUSTING YOUR LOG SPLITTERWedge Assembly AdjustmentAs normal wear occurs and there is excessive “play” between the wedge and beam, adju

11on the tank, hydraulic pump or valve. For this job, contact your nearest service dealer. Hydraulic Filter• Change the hydraulic filter every 50 hour

12SECTION 7: STORING YOUR LOG SPLITTERPrepare your log splitter for storage at the end of the season or if the log splitter will not be used for 30 d

13Hydraulic TroubleshootingNOTE: For repairs beyond those listed here, contact your nearest authorized service center.Problem Cause RemedyCylinder rod

14SECTION 9: PARTS LIST FOR MODEL LS275123461189101314151617181920212223122425BABCCA57122626272829303132333435363738394041424344454647484880495051525

15Model LS275 Ref. No.Part No. Part Description1. 718-0769 Hydraulic Cylinder2. 727-0634 Hydraulic Tube3. 710-1018 Hex Cap Screw 1/2-20 x 2.754. 737-0

MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used

2TABLE OF CONTENTSContent PageImportant Safe Operation Practices... 3Assembling Your L

3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESGeneral Practices1. Read, understand, and follow all instructions on the machine and in the manual(s) b

4equipment. move machine to another area. Wait 5 minutes before starting the engine.i. Never store the machine or fuel container inside where there is

5SECTION 2: ASSEMBLING YOUR LOG SPLITTERUnpacking from Crate• Pry top, sides, and ends off the crate. Set panels aside to avoid tire puncture or pers

6• Disconnect the log cradle from the beam on the side of the control valve. See Figure 4.Figure 4• Lift and slide the cylinder up to the top of beam

7SECTION 3: KNOW YOUR LOG SPLITTERCompare the illustration in Figure 7 below with the controls on your log splitter, and get familiar with its featu

8SECTION 4: OPERATING YOUR LOG SPLITTER Gas and Oil Fill-Up• Service the engine with gasoline and oil as instructed in the engine manual packed with

9Horizontal Position• Pull the vertical beam lock out and rotate it down. See Figure 7. Pivot beam to the horizontal position. The beam will lock auto